scralatchtica824
Active member
- Joined
- Feb 11, 2010
- Messages
- 32
Retails for $445.00 Selling for $275 shipped.
First to message/email me gets the set. Don't miss out!!
Set, Tap and Die, U.S./Metric Combination, 117 pcs. (1/4" to 1/2" NF/NC, 3mm to 12mm)
Item#: TDTDM117A
-------
Description:
Includes all components of the TDTDM500A U.S./Metric Set plus 41-piece high speed steel drill bit set in fractional, metric, wire gauge and letter sizes and five spiral screw extractors. Each drill bit matches to corresponding tap size for correct fit. Set offers a complete assortment of high-carbon steel taps and dies in fractional and metric sizes. Tap/drill charts and tool diagrams included. Set packaged in a storage case.
Additional Description:
An important feature of the dies in these sets (except GA541 and GAM540) is a small adjusting screw which changes the nominal size .003" under or over to give a tight or loose fit to your thread. Die size 1/4" to 1/2" and 7 mm to 12 mm are a one-piece, 12-point design that can be turned with a 1" socket wrench (5/8" socket wrench for 3 to 6 mm dies) when working in places where a normal die stock cannot be used. The three largest die stocks (TD10A, TD35, and TD40) are self-centering and adjust to the diameter of the bolt. U.S. Fed. Spec. GGG-T-60 applies to taps; GGG-D-296B applies to dies.
--------
First to message/email me gets the set. Don't miss out!!
Set, Tap and Die, U.S./Metric Combination, 117 pcs. (1/4" to 1/2" NF/NC, 3mm to 12mm)
Item#: TDTDM117A
-------
Description:
Includes all components of the TDTDM500A U.S./Metric Set plus 41-piece high speed steel drill bit set in fractional, metric, wire gauge and letter sizes and five spiral screw extractors. Each drill bit matches to corresponding tap size for correct fit. Set offers a complete assortment of high-carbon steel taps and dies in fractional and metric sizes. Tap/drill charts and tool diagrams included. Set packaged in a storage case.
Additional Description:
An important feature of the dies in these sets (except GA541 and GAM540) is a small adjusting screw which changes the nominal size .003" under or over to give a tight or loose fit to your thread. Die size 1/4" to 1/2" and 7 mm to 12 mm are a one-piece, 12-point design that can be turned with a 1" socket wrench (5/8" socket wrench for 3 to 6 mm dies) when working in places where a normal die stock cannot be used. The three largest die stocks (TD10A, TD35, and TD40) are self-centering and adjust to the diameter of the bolt. U.S. Fed. Spec. GGG-T-60 applies to taps; GGG-D-296B applies to dies.
--------
Last edited: